Installation manual

STS400™ INSTALLATION MANUAL

4.1 MAIN MENU

To enter the Menu press the Up and Down buttons simultaneously. The menu structure is

shown below.

Menu: [Exit] (exits HMI Interface menu)

Test Mode

Focus/Locate

Calibration

Code Setting

View

Extended (enters Extended menu)

Extended: [Exit] (returns to Main menu)

Backup

Yes (performs Backup - uninterruptible)

No (returns to Extended menu)

Restore

Yes (performs Restore - uninterruptible)

No (returns to Extended menu)

To move through the list press and release the Up or Down key.

To select an item or enter a submenu, press and release the Enter key. After executing an

HMI function the display shows a result message and then automatically exits from the menu

structure.

To exit a menu, press and release the Enter key at the [Exit] item.

To exit from a running HMI function, press and release the Enter key. These functions will

also exit upon their configured timeout.

4.2 VIEW MENUS

NOTE

This menu item is only visible if the connected reader is set as master.

Using this menu item, you can select between different views to be shown on the display.