Instruction manual

Connection box C-BOX 300
Installation
S
ubject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group • Tel.: Germany (06 21) 7 76-0 • USA (330) 4 25 35 55 • Singapore 7 79 90 91 • Internet http://www.pepperl-fuchs.com
Date od issue 08/15/2003
13
Figure 4.3 Mounting the C-BOX 300
4.4 Electrical connections and setup
The following figure shows the typical layout.
Figure 4.4 System layout
A PC can be connected to the C-BOX 300 (and consequently to the scanner auxiliary
interface) through the internal 9-pin connector. This allows monitoring of the data
transmitted by the scanner or configuration through the VisoSetup utility (see scanner
Installation Manual for more details). The scanner auxiliary interface signals are also
available on the internal spring clamp connectors.
After making system cabling and switch settings connect the scanner to the 25-pin
female connector on the left side of the C-BOX 300 housing.
Switch ON the C-BOX 300 power switch (Figure 4.5).
By default, after power on, an automatic connection procedure takes place between
TX DATA EXT TRIG GOOD READ POWER ON
C-Box 300
Scanner
PROFIBUS
Master
System wiring