System information

DS2400N QUICK GUIDE
6
4. Exit the process by pressing the X-PRESS™ push button once. The scanner will restart at the end of the
process, and then the detected barcodes are automatically configured in scanner memory.
NOTE
If the barcode cannot be read because of low contrast or excessive ambient light, you can
perform the AutoSetup function to optimize the optical parameters. Then you can perform
AutoLearn to recognize the barcode symbology.
AUTO SETUP (OPTIONAL)
At the end of the Auto Learn procedure, you have the possibility to follow the Auto Setup procedure to set up the
reading parameters.
1. Enter the Auto Setup function (F3) by pressing the X-PRESS™ push button.
2. Hold the push button pressed until the F3 LED is on.
3. Release the button to enter the Auto Setup function.
4. Once entered, if a barcode label is positioned in front of the scanline, the scanner automatically performs the
optimal setup of the reading parameters for that specific barcode.
F4
F3
F2
F1
F0
READY
GOOD
T
RIGGER
COM
STATUS
A
utoSetup
A
utoLearn
Test Mode
Exit
Figure 5 – X-PRESS™ Interface: Auto Setup Function
The procedure is as follows:
A) place the desired barcode on the scanline.
B) enter the AutoSetup function (the laser turns
on and the GOOD LED blinks to indicate the
ongoing process)
C) wait until the GOOD LED stays steady on
(indicating the reader has detected the
barcode)
This procedure ends either when the barcode is successfully decoded or after a timeout of about 7 (seven) seconds.
The scanner will restart at the end of the process, and then the optimized reading parameters for that barcode are
automatically configured in scanner memory.
NOTE
If your application has been configured using X-PRESS™, go to STEP 5.