System information

DS2400N QUICK GUIDE
3
STEP 1 – CONNECT THE SYSTEM
To connect the system in a Stand Alone configuration, you need the hardware indicated in Figure 1.
In this layout the data is transmitted to the Host on the main serial interface.
In Local Echo communication mode, data is transmitted on the RS232 auxiliary interface independently from the
main interface selection.
When On-Line Operating mode is used, the scanner is activated by an External Trigger (photoelectric sensor)
when the object enters its reading zone.
Figure 1 – DS2400N in Stand Alone Layout
C-BOX 100/150 Pinout for DS2400N
The table below gives the pinout of the C-BOX 100/150 terminal block connectors. Use this pinout when the
DS2400N reader is connected by means of the C-BOX 100/150:
C-BOX 100/150 Terminal Block Connectors
Power Outputs
1, 3, 5 VS 21 OUT 1+
2, 4, 6 GND 22 OUT 1-
7, 8 EARTH GROUND 23 OUT 2+
20, 40 Reserved 24 OUT 2-
Inputs
25 NC
27 EXT TRIG A (polarity insensitive) 26 NC
28 EXT TRIG B (polarity insensitive)
Auxiliary Interface
29 NC 35 TX AUX
30 IN2- 37 RX AUX
31, 33 NC
ID-NET™
32, 34 NC 36 ID-NET-
39 GND 38 ID-NET+
Main Interface
RS232 RS485 Full-Duplex RS485 Half-Duplex 20 mA C.L. (with INT-30 only)
11, 15 TX 232 TX 485+ RTX 485+
12, 16 RTS 232 TX 485- RTX 485-
17 RX 232
*RX 485+
18 CTS 232
*RX 485-
10, 14, 19 SGND SGND SGND
9, 13 RS485 Cable Shield RS485 Cable Shield
see INT-30 instructions
* Do not leave floating, see Reference Manual for connection details.
CAUTION
Do not connect GND and SGND to different (external) ground references. GND and SGND
are internally connected through filtering circuitry which can be permanently damaged if
subjected to voltage drops over 0.8 Vdc.
DS2400N
Host
PG 6000
P.S.*
* Presence Sensor
(for On-Line mode)
CBOX-100/150