Installation manual

INSTALLATION
17
2
2.7.1 GET/SEND Buttons
The C-BOX 200 has two internal function buttons (GET, SEND). The procedure to
enable the GET/SEND function is the following:
1. Press both the buttons GET and SEND at the same time for at least one second;
the warning LED is turned ON.
2. Release the buttons.
GET SEND
3. Press the left button corresponding to the GET function or press the right button
corresponding to the SEND function.
GET
– (left button): the C-BOX 200 reads the current scanner configuration and
permanently copies it in its own memory support (EEPROM). The C-
BOX 200 preserves this configuration also when switched off.
SEND
- (right button): the C-BOX 200 sends the configuration previously stored in
its own permanent memory support to the scanner’s EEPROM.
NOTE
Once the buttons are released in step 1, a ten-second timeout starts.
If no button is pressed within this time, the procedure will be
cancelled.
In any case, the warning LED is turned OFF at the end of each
procedure.