Installation manual

C-BOX 200
10
2
2.4.3 Chassis Grounding Jumper Settings
The scanner chassis grounding method can be selected by positioning a jumper (see
Figure 9). In this way the scanner chassis can be connected to earth ground (only if
pins 7 or 8 are connected to a good earth ground) or to the power supply ground
signal. The scanner chassis can also be left floating but, in this case, the jumper
must be removed.
to EARTH
GROUND
(default)
to GND floating
Figure 9 – Chassis grounding
The C-BOX 200 is now installed which completes the electrical connections for your
scanning system.