Installation manual

C-BOX 200

2.4 ELECTRICAL CONNECTIONS AND SETUP

The following figure shows the typical layout. The dotted line in the figure refers to an

optional hardware configuration.

SCANNER

System Cables

Scanner

Auxiliary

Interface

TX DATA

EXT TRIG

GOOD READ

POWER ON

Figure 5 – System layout

A PC can be quickly connected to the C-BOX 200 (and consequently to the scanner

auxiliary interface) through the internal 9-pin connector. This allows monitoring of the

data transmitted by the scanner or configuration through the WinHost utility (see the

scanner Installation Manual for more details). The scanner auxiliary interface signals

are also available on the internal spring clamp connectors.

After making system cabling and switch settings (see sub-paragraphs under 2.4),

connect the scanner to the 25-pin connector on the left side of the C-BOX 200

housing.

Switch ON the C-BOX 200 power switch (see Figure 6).

After power on, an automatic connection procedure takes place between the C-BOX

200 and the scanner. During this phase, requiring a few seconds, the warning LED is

turned ON. Once the procedure had been completed successfully, the warning LED

is turned OFF.

After system functioning has been verified, close the C-BOX 200 using the 4 cover

screws making sure the rubber seal is fitted correctly between the parts of the

housing.