Instruction manual

A30 QUICKSTART GUIDE
6
Figure 1 – Assembling the Camera and Lens
4. To keep dust and dirt off of the lens during mounting, temporarily replace the lens cover.
Connect the System
In the typical standalone layout shown in the figure below, an EtherNet host is connected to the
camera. The camera can use an external trigger to signal image acquisition.
The CBX is used to facilitate the connection between the camera and the host interface, external
trigger, and optional input and output devices.
A30™ Standalone Layout to Ethernet Host
• Power Supply Connection
CAB-GE0x
CAB-PG-0002
+ BA400
CAB-SCSxx
PG-120
Ext. Trigger
CBX500
I/O
Ethernet Host
(Data collection + A30
configuration)
Camera
Lens
Lens Cover
Lens Spacer
(optional)
Protective Film
(remove before calibration)
Camera