Instruction manual

GENERAL VIEW
5
GENERAL VIEW
A30™ Camera
1
Power Indicator LED
2
Power, Serial Interface, and I/O Connector
3
MAC Address label
4
Ethernet Connector
5
Ethernet Network Presence LED
6
Indicator Lights (see page 7)
7
Reset and Camera Button Event (see page 7)
Configuration
ASSEMBLE THE CAMERA
The first step to perform is to assemble any accessories that make up the A30™ camera. A lens
must be used. A strobe or other external illuminator may be required.
CAUTION
The camera must be disconnected from the power supply during this
procedure.
1. In a dust-free environment, remove the Camera Lens Cover by unscrewing it.
CAUTION
Do not touch the sensor aperture, lens glass or lens cover glass. These
areas must be kept clean. Avoid any abrasive substances that might
damage these surfaces during cleaning.
2. Remove the sensor protection label (dust cap) by pulling it off of the base.
3. Mount a lens by slowly screwing it onto the base until it arrives at the mechanical stop.
1
4
2
5
3
7
6