Hardware manual

Impact Reference Guide Device Settings
3-215 Datalogic Automation Inc.
Enable Camera
Shutter Speed
If True, this tool’s Camera Shutter Speed value is sent to the camera
when the tool runs.
Camera Shutter
Speed
Shutter Speed (Open Time) indicates the amount of time the shutter is
open. The higher the number, the longer the shutter is open and the
brighter the image.
Enable Camera
Internal Correction
If True, the camera’s internal correction is enabled when the tool runs.
Camera Internal
Correction
The camera’s internal correction for gain and offset.
Enable Camera
Trigger Edge Type
If True, this tool’s Camera Trigger Edge Type value is sent to the camera
when the tool runs.
Camera Trigger
Edge Type
This value sets the Camera Trigger type as follows:
1 = Rising Edge
2 = Falling Edge
3 = Both Edges (See “Trigger Tab” on page 2-19) (Not available on M-
Series processors)
Enable Image Scan
Left Edge
If True, this tool’s Scan Left Edge value is sent to the camera when the
tool runs.
Image Scan Left
Edge
This value sets the left edge where the camera’s horizontal scan will
start. The default value is determined by the camera type. (See *Note
below this table)
Enable Image Scan
Right Edge
If True, this tool’s Scan Right Edge value is sent to the camera when the
tool runs.
Image Scan Right
Edge
This value sets the right edge where the camera’s horizontal scan will
stop. The default value is determined by the camera type. (See *Note
below this table)
Enable Image Scan
Top Edg e
If True, this tool’s Scan Top Edge value is sent to the camera when the
tool runs.
Image Scan Top
Edge
This value sets the top edge where the camera’s vertical scan will start.
The default value is determined by the camera type. (See *Note below
this table)
Enable Image Scan
Bottom Edge
If True, this tool’s Scan Bottom Edge value is sent to the camera when
the tool runs.
Image Scan Bot-
tom Edge
This value sets the bottom edge where the camera’s vertical scan will
stop. The default value is determined by the camera type. (See *Note
below this table)
Enable Units Per
Pixel
If True, this tool’s Units Per Pixel value is sent to the camera when the
tool runs.
Units Per Pixel Units per Pixel is the scale factor for converting measurements in the
image to "real world" units. See “Calibrate Manually” on page 2-29 for
details.
Input Name What it is