Hardware manual

Impact Reference Guide Impact Wait For Message
3-197 Datalogic Automation Inc.
2. Click the Browse button. When the Select Message Destination dialog is displayed, select the desired
Destination Camera from the list.
3. Click OK. The camera’s IP Address and name is displayed.
4. Enter the desired Message Number in the Message Number field (from 0 to 255). There should be an
Impact Wait For Message tool in a task in the Destination Camera that uses the same Message Number.
5. To test the tool, click the Send button. The Pass/Fail status is True if the message was sent. This does
not imply that the corresponding Wait For Message tool received the message.
Impact Wait For Message
In the Communication Drawer
The Impact Wait For Message tool works with the Impact Send Message tool to receive data from another
Impact camera. There is a setup for this tool. See “How to set up the Impact Wait For Message tool” on
page 3-198.
NOTE: To use this tool with an A10, A20, T3x, or C-Series smart camera, the property Enable Maximum
Timestamp Difference must be disabled.
Input Name What it is
Number The Message number (from 0 to 255). The corresponding Impact Send
Message tool must use this number in the Number property.