Hardware manual

Impact Reference Guide Code Reader
3-177 Datalogic Automation Inc.
NOTE: The tool will train on a maximum of thirty code symbols in one image. Additional symbols are
ignored and a warning message is displayed below the image.
8. Click the Pass/Fail Radio button. The tool’s Pass/Fail status and statistics about found codes are dis-
played. If there are multiple codes in the image, select an ROI to display that code’s statistics.
9. You can define filters to look for one or more code characteristics. If those characteristics match a
found code, it is decoded and output. If all the filters pass, the tool passes. If any one of the filters fail,
the tool fails. If no filters are defined or enabled, all the defined codes found in the image are output
and the tool passes. If the tool has not been trained to find a code type, any filters defined for it will
automatically fail and the tool will fail.
Enable All: Enables all the filters. The tool will pass if all the conditions in all the filters are met.
Disable All: Disables all the filters. The tool will always pass if a defined code type is in the image.
Add and Edit: Click Add, or select a filter and click Edit. The Edit Filter dialog is displayed. For more
details see “Using the Pass Fail Filters” on page 3-179.
Delete: Select the filter you want to delete, then click Delete.
A check indicates the Code
Type is enabled.