Hardware manual

Angle Impact Reference Guide
Datalogic Automation Inc. 3-112
How to set up the Angle tool
1. Snap a good image of the desired part, then click the Setup tab.
2. Click the ROI radio button.
2a. To use the tool’s built-in Line Find ROIs:
• Select the type of Line 1 or Line 2 you want to find: First Dark Line or First Bright Line.
• Position the Wide Line ROIs for the desired lines on the edges you want to find. Be sure that the ROIs
are oriented and aligned as desired. To adjust the ROIs, hold the cursor over an adjustment point until
Angle Endpoint Choose whether or not to consider the direction of the angle’s end line
when measuring the angle. See “How to set up the Angle tool” on
page 3-112.
Enable Angle
Range Check
If True, the tool will pass if the measured Angle value is within the Angle
Range limits.
Angle Range If Enable Angle Range Check is True, the tool will fail if the measured
Angle value falls outside these limits.
Output Name What it is
Angle The measured Angle’s value. This is always a positive number from 0 to
360.
Passed If True, the measured Angle value is within the Angle Range Limits or
Enable Angle Range Check is False.
Arc The measured Angle displayed as a Wide Circular Arc ROI.
Intersection The intersection point of the Angle’s measurement lines, displayed as an
Origin aligned with Line 1.
Found Line 1 The line segment found by Wide Line ROI 1, if Line 1 type is Find Bright
Line or Find Dark Line. This value is zero if the Line Segment or Origin is
linked.
Found Line 2 The line segment found by Wide Line ROI 2, if Line 2 type is Find Bright
Line or Find Dark Line. This value is zero if the Line Segment or Origin is
linked.
Input Name What it is