Hardware manual

Configuring the Impact Device or Camera Impact Reference Guide
Datalogic Automation Inc. 1-4
1. Start VPM. When the “Select a Device to Connect to” dialog is displayed, click on the desired device
or camera in the list of Devices found. If the device or camera is not in the list, be sure the device or
camera power is on and that it is connected to the client computer, then click the Refresh button.
2. Click the Edit IP Address button at the bottom of the dialog.
3. In the “Edit IP Address dialog,” enter the desired IP address and IP mask. Leave the IP Gateway
unchanged.
IMPORTANT: Do NOT include a leading zero in an IP Address group (for example 192.168.108.065)
4. Click OK.