Integration Guide

I2C Command Specifications
34 DE2011-DL
SET LOW POWER (0x3F)
Activates system power saving mode. This command can
only be used when the camera is stopped (no image
acquisition is in progress), since it puts both the
microcontroller and the image sensor into sleep mode.
The system wakes up and returns to normal power mode
each time a command is issued.
SET SENSOR REG (0x30)
Stores the new chosen value for the desired register of
the Aptina MT9V024 image sensor. Further details on the
sensor can be found on the MT9V024 manual.
Modifying registers manually bypasses the engine system
control over the sensor. This could cause the image
sensor to behave in a way that conflicts with the engine
system working setup and normal operation.
CAUTION
Unpredictable camera behavior may occur.