Integration Guide

I2C Command Specifications
32 DE2011-DL
ILLUMINATION DELAY (0x34)
Sets the illumination delay time taking as a starting point
Sensor Exposure start. Accepts values from 0x00 to 0xFF
with a time unit of 30us.
ILLUMINATION ENABLE (0x39)
With the value set to 0x01 the illumination LEDs will turn
on whenever the camera is acquiring images. Setting the
value to 0x00 will always turn it off.
ILLUMINATION TIME (0x48)
Sets the illumination light duration within each frame,
with a 50us time increment. Values are from 0x00 (0us)
to 0x14 (1ms).
RESTORE FACTORY DEFAULT (0x23)
The following User Custom Parameters values are
restored to their Factory Default:
ILLUMINATION PULSE DURATION
I
LLUMINATION DELAY
AIM PULSE DURATION
AIM DELAY
SENSOR AEC MAX EXPOSURE
See Table 7
on page 24 for Factory Default values.
RUN CMD LIST (0x47)
Executes the sequence of commands previously
memorized using the SET CMD LIST command.
SET AUTO POWER TIME (0x45)
Sets the timeout value after which power saving mode is
activated. When camera is idle and AUTO LOW POWER is
active the timer starts counting; whenever any command
is issued the timer resets.
SENSOR BINNING (0x3C)
Modifies sensor register values for image binning:
merging of adjacent pixels with a consequent change of
resolution and variation in output image signals timing.
A bin of x means that x adjacent pixels are merged
(column or row wise), which means that resolution is
(current resolution)/x (on columns for “Column Binning”
or rows for “Row Binning”). Column Binning also divides
pixel clock frequency by x; row binning also multiplies by
x the camera FPS. Binning is applied to the context A or B,
depending on the current active CAMERA MODE (see
command).