Integration Guide

Software Interface
20 DE2011-DL
CAMERA SYSTEM CONFIG
[0x23] RESTORE
FACTORY
DEFAULT
clears Camera USER
CUSTOM parameters,
bringing them back to
FACTORY DEFAULT
values
1 Byte:
00
[0x3F] SET LOW POWER Activates system power
saving mode
1 Byte:
0x00=Normal
0x01=Low Power
[0x40] GET CAMERA
PARAM
Returns chosen Camera
parameter (stored in
EEPROM).
2 Bytes:
Parameter ID Code
n Bytes:
Parameter current
value; number of
bytes depending
on parameter
‡
[0x41] SET CAMERA
PARAM
Sets desired value to
chosen Camera USER
CUSTOM parameter
(stored in EEPROM).
2 Bytes:
Parameter ID Code
+
n Bytes:
parameter data
‡
2 Bytes:
Parameter ID
Code
[0x44] AUTO LOW
POWER
System automatic power
saving mode.
1 Byte:
00=Disabled
01=Enabled
[0x45] SET AUTO
POWER TIME
Sets the time to power
saving mode when camera
is idle (AUTO LOW POWER
must be active).
1 Byte:
0x01
- 0x0A = 10-
100 ms, 10 ms
increments
0x0B - 0x14 = 100-
900 ms, 100 ms
increments
0x15 - 0xFF = 1s -
235 s, 1 s increments
0x00 = 5 ms
AIMING SYSTEM
[0x35] AIM TOGGLE Switches the aiming
system ON/OFF.
1 Byte:
00=Off
01=On
‡
See Table 6 on page 23 and Table 7 on page 24 for details on parameter length and ID code.
Cmd
Code
Cmd Name Description Parameters
Response Data
(if present)