User's Guide

OM-GRYPHON™
1
USING OM-GRYPHON™ RADIO CRADLE
The OM-GRYPHON™ cradle, paired with one Gryphon™ M series reader,
builds a Cordless Reading System for the collection, decoding and transmission
of barcoded data.
USB multi-standard interface models can be connected to a Host PC through a
USB, RS232, Wedge or Pen emulation cable. IBM models can be connected to
an IBM 46xx Terminal, a USB or an RS232 interface. All models are suited for
single-cradle layouts.
The LEDs signal the OM-GRYPHON™ status, as described in the following
table:
LED STATUS
Power on /
Data
Yellow On = OM-GRYPHON™ is powered.
Yellow Blinking = OM-GRYPHON™ receives data and
commands from the Host or the reader.
Charging
Red On = the battery charge is in progress.
Red Blinking = the battery reconditioning is in progress.
Charge
completed
Green On = the battery is completely charged.
Charging +
Charge
completed
Red and Green Blinking together = the reader is not
correctly placed onto the reader.
D
I
S
C
H
A
R
G
E
To setup your OM-GRYPHON™ cradle you must:
1. Make all system connections.
2. Configure the OM-GRYPHON™ cradle.
Power on / Data
(yellow LED)
Reconditioning battery
button
Charging
(red LED)
Charge completed
(green LED)