User's Guide

OM-GRYPHON™
19
COPY CONFIGURATION
This procedure allows using a previously configured Gryphon™ M reader
(Master) to send its configuration directly to other devices of the same type
(Slaves) by means of a single OM-GRYPHON™.
Proceed as follows:
With the master Gryphon™ M (correctly configured reader), read the
Copy Configuration barcode below. Then, place it onto the
OM-GRYPHON™ cradle within 10 seconds. The reader will beep
indicating the configuration has been copied.
Copy Configuration
Ì$+ZZ0$-*Î
1.
2.
With the slave Gryphon™ M, read the Get Configuration barcode
below. Then place it onto the same OM-GRYPHON™ cradle used in
the step above. The slave reader's address will not be changed
.
Get Configuration
Ì$+ZZ2$-4Î
The configuration will be copied from the master to the slave
Gryphon™ M. The slave Gryphon™ M signals the end of the
procedure with a series of beeps.
3.
Repeat the procedure above to configure other slave readers. The
OM-GRYPHON™ can continue to configure slave readers until it
receives another command.
NOTE
This procedure does not require connection to a PC, however
by connecting the RS232 interface cable to the
OM-GRYPHON™ the copied configuration will be sent to the
PC.