User's Manual

INITIAL SETUP

4.1.3 USB Configuration and Selection

The USB interface is compatible with:

Windows 98 (and later) IBM POS for Windows

Mac OS 8.0 (and later) 4690 Operating System

USB START-UP

As with all USB devices, upon connection, the Host performs several checks by

communicating with the OM-1000 BT. Before the OM-1000 BT is ready, the correct

USB driver must be loaded.

For all systems, the correct USB driver for the default USB-KBD interface is included

in the Host Operating System and will either be loaded automatically or will be

suggested by the O.S. and should therefore be selected from the dialog box (the first

time only).

You can now read codes with the associated Lynx™ BT reader. At this point you can

read the USB interface configuration code according to your application. Load drivers

from the O.S. (if requested). When configuring the USB-COM interface, the relevant

files and drivers must be installed from the USB Device Installation software which

can be downloaded from the web site: http://www.datalogic.com.

The OM-1000 BT is ready.

Connect OM-1000

BT to Host

Select desired USB interface

code (USB-KBD is default)

Read test codes.

OM-1000 BT is READY

Load drivers

(if requested)

Load drivers

(

if re

uested

)

First Start-Up

Successive start-ups will automatically recognize the previously loaded drivers.