User's Manual

INSTALLATION
9
2
NOTE
It is always necessary to use an external power supply connected to
the OM-1000 cradle.
USB Connection
The OM-1000 cradle requires the USB interface cable and the AC/DC power adapter
to be connected.
To install your cradle to your host system, follow these instructions (see Figure 5
below).
1. After charging the batteries (see par. 1.2), bind the Lynx™ BT to the OM-1000
BT by following the procedure given in par. 4.1.3;
2. Insert the USB cable into the OM-1000 cradle;
3. Connect the USB cable to the PC;
4. Connect the power cord to the OM-1000 cradle;
5. Connect the AC/DC power adapter at the wall outlet.
6. Upon OM-1000 power up, wait for the series of beeps indicating Bluetooth
connection.
7. Read the correct USB interface code for your application in par. 4.1.3.
8. Connect the USB interface cable to a free USB port. The PC automatically
recognizes the device and asks to install the device driver.
9. Install the USB driver on your PC (the first time only) to complete the connection.
• For USB COM the relevant files and drivers must be installed from the
USB Device Installation software which can be downloaded from the
web site http://www.datalogic.com
.
• For USB Keyboard the correct USB driver is included in the Host
Operating System and will either be loaded automatically or will be
suggested by the O.S. and should therefore be selected from the
dialog box.