User's Manual

LYNX™ BT
8
2
Wedge
CAUTION
Connections should always be made with both PC and Cradle
power off!
The OM-1000 cradle requires the Wedge interface cable and the AC/DC power
adapter to be connected.
To install your cradle to your host system, follow these instructions (see Figure 4
below).
1. After charging the batteries (see par. 1.2), bind the Lynx™ BT to the OM-1000
BT by following the procedure given in par. 4.1.2;
2. Insert the Wedge cable into the OM-1000 cradle;
3. Connect the power cord to the OM-1000 cradle;
4. Connect the AC/DC power adapter at the wall outlet;
5. Upon OM-1000 power up, wait for the series of beeps indicating Bluetooth
connection.
6. BEFORE CONNECTING THE WEDGE CABLE TO THE PC AND KEYBOARD,
read the Wedge IBM AT interface code in par. 4.1.2.
7. Connect the WEDGE interface cable between the keyboard and the host
terminal.
8. Power up your PC.
Wedge AT is the default interface set at the factory.
Figure 4 - Wedge Connection
CAUTION
When not using the OM-1000 cradle remember to disconnect the
Wedge interface from the PC before disconnecting the power cord.