User's Manual

LYNX™ BT
6
2
2.1.1 OM-1000 BT Interface Cable Connections
The OM-1000™ can be connected to a Host by means of an RS232, Wedge or USB
cable which must be simply plugged into the Host connector, visible on the rear panel
of the cradle.
To disconnect the cable, insert a paper clip or other similar objects into the hole
corresponding to the Host connector on the body of the cradle. Push down on the clip
while unplugging the cable. Refer to the following figure:
Figure 2 – Connecting/Disconnecting the Cable
Multi-standard interface
RS232, WEDGE, or USB
to Host
Power