User's Manual

LYNX™ BT
2
1
1.2 LYNX™ BT BATTERIES
To begin using your Lynx™ BT you must charge its batteries using the OM-1000 cradle
or the C-1000 battery charger as described in the following paragraph. You can install
Li-Ion batteries in the Lynx™ BT.
Battery Charging
The first operation to perform is to connect the OM-1000 or the C-1000 to the power
converter and firmly insert the Lynx™ BT into the cradle to charge the batteries. The
red Charging LED will light. A full charge takes about 3.5 hours. The Batt. Full LED will
light when charging is completed. Press the reader trigger to turn it on.
Figure 1 – OM-1000 BT Charging Batteries
The LEDs positioned on the cradle signal the status, as described in the following
table:
LED STATUS
Pwr/Data Yellow On = cradle is powered
Yellow Blinking = cradle receives commands from Host
Charging Red On = the battery charge is in progress
Batt Full Green On = the battery is completely charged
Power Cable