User's Manual

INSTALLATION

2.2.1 Lynx™ BT as Slave

Once set as Slave, a Lynx™ BT reader requires no particular configuration for

communication, however some radio parameters can be set to increase system

performance and data transmission security. At startup the reader can only wait for

the Master to initialize the radio communication.

The following is a general procedure recommended for Lynx™ BT Slave

applications:

1. Power up the remote Bluetooth

Master device (example Laptop or PC).

2. Power up the Lynx™ BT reader within radio range (10 meters).

Any modifications to the radio configuration should be made at this time before

the radio connection takes place.

3. From the remote Bluetooth

Master device, execute the Discovery procedure,

(according to the procedure given in the documentation of the Bluetooth

Master

device), to recognize the Lynx™ BT reader(s) within radio range.

4. Check that "Lynx BTx00 " is shown among the discovered devices.

5. Request to open an SPP connection with Lynx™ BT, making sure to disable any

required PIN and/or pairing parameters. Lynx™ BT is always discoverable and

connectable without any required PIN.

NOTE

If the PIN of the Bluetooth

Master device cannot be disabled, use the

PIN "1234". The Lynx™ BT Slave will emit four ascending tones

indicating radio connection.

After the Lynx™ BT reader(s) indicate radio connection (see also par. 10.1), you can

start sending barcodes.