User's Manual

INTRODUCTION
3
1
Replacing Lynx™ BT Batteries
To change the batteries in the Lynx™ BT, unscrew the
battery cover screw, replace the old battery pack with a
new one of the same type, then insert the cover onto the
handle and screw it back into place. See the following
figures.
To turn on the reader, press the trigger.
WARNING
Risk of explosion if the battery is replaced by an incorrect
type. Dispose of the batteries as required by the relevant laws
in force.
1.3 CONFIGURATION METHODS
1.3.1 Reading Configuration Barcodes
This manual can be used for complete setup and configuration. If you wish to change
the default settings, you can configure the Lynx™ BT reader by reading the
programming barcode symbols in this manual. Configuration commands and their
relative arguments are read individually using the symbols in this manual. See
chapter 4, and Appendix C.
Battery Cover Screw