User's Manual

DATALOGIC JET™
42
4
CAUTION
When the latch release button is pressed, the PDA automatically
shuts off, in order to retain data during the pack substitution. After
the new pack insertion, be sure that the battery latch has
completely slid over the pack so that the latch release button is
released.
WARNING
Risk of explosion if the battery is replaced by an incorrect
type. Dispose of the batteries as required by the relevant laws
in force.
NOTE
In order to guarantee an adequate operating autonomy, when
replacing the battery pack the PDA checks the battery energy level.
If the battery is not sufficiently charged, Datalogic Jet™ does not
turn on (when pressing the ON button).
In this case, either substitute the battery pack with a charged one
(sufficiently charged) or insert Datalogic Jet™ into a powered cradle
or plug it into the direct power supply.
4.3 CLEANING THE PDA
Periodically clean the Datalogic Jet™ PDA with a slightly dampened cloth.
Do not use alcohol, corrosive products or solvents.
A
B
4. Replace the battery pack by pressing
the latch release button and pulling
the battery latch down (A), and then
by inserting it towards the speaker (B)
and pressing it into the Datalogic
Jet™ PDA until the battery latch is
automatically closed: