User's Manual

DATALOGIC JET™
14
3
3.3.2 Imager Data Capture
To read a 1D or 2D code, simply point the Datalogic Jet™ Imager model onto the
code from a distance within the reading range (See par. 5.1, section Datalogic Jet™
Imager Optical Features) and press one of the three SCAN Keys.
The Datalogic Jet™ Imager uses an intelligent aiming system similar to those on
cameras, which creates a field of view where the code is to be positioned:
Aiming System
If the aiming system is centered and the entire symbology is within the aiming system
as shown below, either wait for the timeout or release the Scan Key.
A red beam illuminates the code, which is captured and decoded. You will get a good
read.