User manual

Product Reference Guide F-1
Appendix F
Programming Parameters
Overview
This section contains information about programmable settings for the Pegaso with
Windows CE. Use the Falcon Management Utility (FMU), the Decoding Control
Panel applets, or the bar codes provided in Appendix G to program the Pegaso.
Table F-2 starting on page F-3 provides the following information:
• Code Parameter is the “human” name for the programming option.
• I.D. # is the “decoder” name for the programming option. For example, to set a
Code 39 minimum label length, use I.D. 0120. Programming I.D. numbers given
in this appendix can be used with all programming methods.
• On/Off is a toggle. 1 turns the parameter on, and 0 turns it off.
• Acceptable Input gives the settings or range of settings for each code parameter.
• Defaults indicates how the parameter is set when the predefined default FF39,
FF3A, or FF3B is selected.
• Minimum (FF39) turns every on/off parameter off and sets all minimum and
Maximum Label Lengths to the lowest values.
• Maximum (FF3A) turns every on/off parameter on, sets all Minimum Label
Lengths to the lowest values, and sets all Maximum Label Lengths to the highest
values. Use this default for troubleshooting; it provides the best settings for read-
ing an unknown bar code symbology and can ide
ntify the symbology of scanned
bar codes.
• Factory (FF3B) is the factory setting installed on the Pegaso. This default set will
work for most applications. To reset the Pegaso to the original defaults, scan the
Factory bar code on page G-2.