User's Manual
Table Of Contents
- Falcon® 4400 Series
- with Windows® CE
- Quick Reference Guide
- Table of Contents
- Falcon® 4400 Series with Windows® CE
- Appendix A: Datalogic Mobile Falcon® Windows® CE Series End User License Agreement
- Appendix B: Microsoft® Windows® CE End User License Agreement
- Appendix C: Datalogic Mobile Falcon® Windows® CE Product Series Warranty
- Appendix D: Safety Information
- Appendix E: Laser Safety
Scanning Bar Codes
32 Falcon
®
4400 Series with Windows
®
CE
Figure 19. Scanning a Bar Code
2. Aim the scan window at the bar code following the guidelines outlined
in Figure 20.
3. Press
<Scan> on the keypad (26, 52 or 52-key NU) or the Scan Trigger
on the handle. The laser scans as long as you hold the button or trigger,
or for 10 seconds, or until a good scan is obtained.
4. Aim the laser beam at the center of the bar code.
• Position the unit close to bar code when scanning small bar codes.
• Position it at a distance when scanning larger bar codes.
• The laser is disabled after you release the key or after 10 seconds,
or once a good scan is obtained.
Figure 20. Laser Beam Positions
Press <Scan> on the keypad (26, 52 or 52-key
Correct Scanning Positions
Incorrect Scanning Positions
Ideal positioning
A bit high, will read correctly
A bit angled, will read correctly
Positioned too far to the right. Will
not read entire bar code.
Too angled; cannot read the
entire bar code.
Bar code will not read. The
scanner should be posi-
tioned perpendicular to
the bar code bars.