User's Manual
Table Of Contents
- Introduction
- Quick Start Instructions
- Using the PowerScan RF System
- Mounting the Base Station
- RF Programmable Features
- Programming Overview
- What Is Programming Mode?
- The Programming Session
- Programming Sequence
- Scanner vs. Base Station Features
- Interface (I/F) Selection
- Universal Keyboard Wedge I/F Selection
- Terminal/ Keyboard Settings
- RF Beeper Settings
- RF When to Beep
- RF When to Beep Options (continued)
- Radio Transmit Power
- RF Channel Selection
- Transmission Retries Before Message Time- out
- Wait Time for ACK
- Wait Time For Scanner Power Shutdown
- Wait Time Between Retries of Failed Transmission
- HACK Transmit Options
- Wait Time For HACK From Host
- Drop Links on Reset Option
- Drop Oldest Links Option
- Common Configuration
- Set Maximum Linked Scanners
- Source-Radio Identification (ID)
- Low Battery LED Indication
- Maintenance and Troubleshooting
- Standard Warranty
- Sample Bar Codes
- Number Pad
42 PowerScan™ RF Scanner
Universal
Keyboard
Wedge I/F
Selection
To activate the Universal Keyboard Wedge interface, follow these
instructions:
1. Scan the START bar code.
2. Determine the I.D. of the terminal/keyboard. This information
is available in the Universal Keyboard Wedge Connectivity
Guide (R44-2039), or refer to the Terminal/Keyboard Settings sec-
tion below for a listing of the most common keyboard I.D.s.
3. Scan the ACTIVATE UNIVERSAL KEYBOARD WEDGE
INTERFACE bar code on the following page.
4. Using the "number pad" in Appendix B, scan in the digits for
the keyboard I.D. number you determined in step 2.
5. Scan the END bar code.
SET -------------------------------------------
Activate Universal Keyboard
Wedge Interface ---------
Scan the digit(s) representing the desired keyboard interface type
using the Number Pad in Appendix B, then scan the END bar
code.
END ------------------------------------------