User's Manual
Table Of Contents
- Introduction
- Quick Start Instructions
- Using the PowerScan RF System
- Mounting the Base Station
- RF Programmable Features
- Programming Overview
- What Is Programming Mode?
- The Programming Session
- Programming Sequence
- Scanner vs. Base Station Features
- Interface (I/F) Selection
- Universal Keyboard Wedge I/F Selection
- Terminal/ Keyboard Settings
- RF Beeper Settings
- RF When to Beep
- RF When to Beep Options (continued)
- Radio Transmit Power
- RF Channel Selection
- Transmission Retries Before Message Time- out
- Wait Time for ACK
- Wait Time For Scanner Power Shutdown
- Wait Time Between Retries of Failed Transmission
- HACK Transmit Options
- Wait Time For HACK From Host
- Drop Links on Reset Option
- Drop Oldest Links Option
- Common Configuration
- Set Maximum Linked Scanners
- Source-Radio Identification (ID)
- Low Battery LED Indication
- Maintenance and Troubleshooting
- Standard Warranty
- Sample Bar Codes
- Number Pad
40 PowerScan™ RF Scanner
Enable Keyboard Wedge
Type A
a
---------
Enable Keyboard Wedge
Type B ---------
Enable Keyboard Wedge
Type C ---------
Enable Keyboard Wedge
Type D ---------
Enable Keyboard Wedge
Type E ---------
Enable Keyboard Wedge
Type F ---------
Enable Keyboard Wedge
Type G ---------
Enable Keyboard Wedge
Type H ---------
Enable Keyboard Wedge
Type I ---------
Enable Keyboard Wedge
Type J ---------
END ------------------------------------------
a. See Table 6 for the specific interfaces supported by each of the keyboard
types listed above. See the following section Universal Keyboard Wedge
I/F Selection to enable that interface type.