User's Manual
Table Of Contents
- Introduction
- Quick Start Instructions
- Using the PowerScan RF System
- Mounting the Base Station
- RF Programmable Features
- Programming Overview
- What Is Programming Mode?
- The Programming Session
- Programming Sequence
- Scanner vs. Base Station Features
- Interface (I/F) Selection
- Universal Keyboard Wedge I/F Selection
- Terminal/ Keyboard Settings
- RF Beeper Settings
- RF When to Beep
- RF When to Beep Options (continued)
- Radio Transmit Power
- RF Channel Selection
- Transmission Retries Before Message Time- out
- Wait Time for ACK
- Wait Time For Scanner Power Shutdown
- Wait Time Between Retries of Failed Transmission
- HACK Transmit Options
- Wait Time For HACK From Host
- Drop Links on Reset Option
- Drop Oldest Links Option
- Common Configuration
- Set Maximum Linked Scanners
- Source-Radio Identification (ID)
- Low Battery LED Indication
- Maintenance and Troubleshooting
- Standard Warranty
- Sample Bar Codes
- Number Pad
Systems Manual 39
Interface (I/F)
Selection
It is very important that the scanner and Base Station are each config-
ured to operate with the same interface (I/F) type as the host terminal.
NOTE
The Base Station uses a “smart” cable, which auto-
matically sets the Base Station to the correct I/F
upon power-up and connection to the appropriate
host.
SET -------------------------------------------
Enable Wand Emulation ---------
Enable Standard
RS-232 ---------
Enable Wincor Nixdorf
RS-232 ---------
Enable IBM Port 5B ---------
Enable IBM Port 9B ---------
Enable IBM Port 17 ---------
Enable IBM Port E ---------