User's Manual
Table Of Contents
- Introduction
- Quick Start Instructions
- Using the PowerScan RF System
- Mounting the Base Station
- RF Programmable Features
- Programming Overview
- What Is Programming Mode?
- The Programming Session
- Programming Sequence
- Scanner vs. Base Station Features
- Interface (I/F) Selection
- Universal Keyboard Wedge I/F Selection
- Terminal/ Keyboard Settings
- RF Beeper Settings
- RF When to Beep
- RF When to Beep Options (continued)
- Radio Transmit Power
- RF Channel Selection
- Transmission Retries Before Message Time- out
- Wait Time for ACK
- Wait Time For Scanner Power Shutdown
- Wait Time Between Retries of Failed Transmission
- HACK Transmit Options
- Wait Time For HACK From Host
- Drop Links on Reset Option
- Drop Oldest Links Option
- Common Configuration
- Set Maximum Linked Scanners
- Source-Radio Identification (ID)
- Low Battery LED Indication
- Maintenance and Troubleshooting
- Standard Warranty
- Sample Bar Codes
- Number Pad
Systems Manual 35
4. Maintain a record of all changes made to ensure that you
know if the original factory settings have been changed. Use
the following table to log your custom configuration changes.
RF
Programmable
Feature
Factory
Default
Setting
Your
Setting
Comment
RF When to Beep Option 7
RF Beeper Volume Vol 3
RF Beeper Frequency High
RF Beep Duration 50ms
Radio Transmit Power High
RF Channel Selection Channel 1
Transmission Retries
Before Message Time-
out
3 Retries
Wait Time for ACK 200ms
Wait Time for Scanner
Power Shutdown
1 Second
Wait Time Between
Retries of Failed Trans-
mission
90ms
HACK Transmit Options
HACK upon
Base Station
transmission to
host
Wait Time for HACK
From Host
1 Second
Drop Links on Reset
Option
Disable
Drop Oldest Links
Option
Enable