User's Manual
Table Of Contents
- Introduction
- Quick Start Instructions
- Using the PowerScan RF System
- Mounting the Base Station
- RF Programmable Features
- Programming Overview
- What Is Programming Mode?
- The Programming Session
- Programming Sequence
- Scanner vs. Base Station Features
- Interface (I/F) Selection
- Universal Keyboard Wedge I/F Selection
- Terminal/ Keyboard Settings
- RF Beeper Settings
- RF When to Beep
- RF When to Beep Options (continued)
- Radio Transmit Power
- RF Channel Selection
- Transmission Retries Before Message Time- out
- Wait Time for ACK
- Wait Time For Scanner Power Shutdown
- Wait Time Between Retries of Failed Transmission
- HACK Transmit Options
- Wait Time For HACK From Host
- Drop Links on Reset Option
- Drop Oldest Links Option
- Common Configuration
- Set Maximum Linked Scanners
- Source-Radio Identification (ID)
- Low Battery LED Indication
- Maintenance and Troubleshooting
- Standard Warranty
- Sample Bar Codes
- Number Pad
Systems Manual 31
RF Programmable Features
Use the special programming bar codes contained in this section to set
features that are unique to RF models of PowerScan™ bar code scan-
ners. To program other features that are common to all models, use one
of the following:
- Configurator Express™ On-Screen Programming Kit
- PowerScan
™ Programming Guide
Programming features included in this manual are:
• RF Beeper Settings
• Radio Transmit Power
• RF Channel Selection
• Transmission Retries Before Message Time-out
• Wait Time for ACK
• Wait Time For Scanner Power Shutdown
• Wait Time Between Retries of Failed Transmission
• HACK Transmit Options
• Wait Time For HACK From Host
• Drop Links on Reset Option
• Drop Oldest Links Option
• Common Configuration
• Set Maximum Linked Scanners
• Source-Radio Identification (ID)
• Low Battery LED Indication
NOTE
See References on page 1 for more information
about how to obtain kits, software and manuals for
this product.