User Manual
Table Of Contents
- Introduction
- Quick Start Instructions
- Using the PowerScan RF System
- Mounting the Base Station
- RF Programmable Features
- Programming Overview
- What Is Programming Mode?
- The Programming Session
- Programming Sequence
- Scanner vs. Base Station Features
- Interface (I/F) Selection
- Universal Keyboard Wedge I/F Selection
- Terminal/ Keyboard Settings
- RF Beeper Settings
- RF When to Beep
- RF When to Beep Options (continued)
- Radio Transmit Power
- RF Channel Selection
- Transmission Retries Before Message Time- out
- Wait Time for ACK
- Wait Time For Scanner Power Shutdown
- Wait Time Between Retries of Failed Transmission
- HACK Transmit Options
- Wait Time For HACK From Host
- Drop Links on Reset Option
- Drop Oldest Links Option
- Common Configuration
- Set Maximum Linked Scanners
- Source-Radio Identification (ID)
- Low Battery LED Indication
- Maintenance and Troubleshooting
- Standard Warranty
- Sample Bar Codes
- Number Pad
Systems Manual 45
RF When to
Beep
Several options are available to specify how the RF handheld scanner
will beep to indicate a good read. Settings are based on the enable/dis-
able status desired for three selectable beep indications:
• Good Read Beep
• Acknowledgement (ACK) Beep
• Transmission Error Beep
The available options are described and numbered in Table 7 to corre-
spond with the programming bar codes provided for this feature.
Table 7. RF When to Beep Options
Feature is specific to scanner ONLY
NOTE
These settings supersede any settings made using
the generic "When to Beep" feature listed in the
PowerScan Programming Manual.
#
Good Read
Beep
ACK Beep
Transmission Error
Beep
0 Disabled Disabled Disabled
1
Disabled Disabled Enabled
2
Disabled Enabled Disabled
3
Disabled Enabled Enabled
4
Enabled Disabled Disabled
5 Enabled Disabled Enabled
6
Enabled Enabled Disabled
7
Enabled Enabled Enabled