User's Manual

14 PowerScan
®
PBT7100 Cordless Imaging Reader
Defaults
For your convenience, standard factory defaults
1
are shown here for each
of the major interface types. For more details or to change these settings,
reference the Product Reference Guide (PRG).
RS-232 Standard Default Settings — 9600 Baud, no Parity, 1
Stop Bit, Handshaking disabled, no Intercharacter Delay, Beep on
ASCII BEL disabled, Beep On Not On File enabled, ACK Character =
‘ACK’, NAK Character = ‘NAK’, ACK NAK Timeout Value = 600ms,
ACK NAK Retry Count = 3, ACK NAK Error Handling = Ignore, Indi-
cate Transmission Failure enabled, Disable Reader Command = ‘D’,
Enable Reader Command = ‘E’.
Wand Emulation Standard Default Settings — Wand Idle State =
Low, Wand Polarity = Quiet Zones & Spaces High - Bars Low, No Label
Symbology Conversion, Transmit Noise = Disabled.
OEM/IBM Standard Default Settings — OEM-USB Device Usage
= Table Top Reader, Transmit Labels in Code 39 Format = OEM Stan-
dard Format, 46xx Number of Host Resets = 6.
USB Standard Default Settings — USB Keyboard Speed = Fast
(1ms).
Keyboard Standard Default Settings (Keyboard AT) — Coun-
try Mode = U.S., Caps Lock= OFF, Numlock Key =Unchanged, Send
Control Characters = Disabled, Wedge Quiet Interval = 100ms, No
Wedge Intercode Delay.
1. Applicable only when the reader is connected to a host via the Base Station.