User Manual
Table Of Contents
- Introduction
- Getting Started
- Simple Tests
- Quantitative Quantitative Tests
- Transmitter Only Transmitter Only
- Receiver Only
- Loopback Test Mode
- Configuration Commands
- Built-in-Self Test (BIST) Routines
- Miscellaneous Test Routines
- Persistent Store Keys
- Appendix 1 BIST Parameters
- Appendix 2 Known Software Issue(s) in BlueTest Version 1.4
- Appendix 3 Combining Tests Using a Second Unit
- Appendix 4 Configuration Commands Available During Tests
- Appendix 5 Bluetooth Packet Types
BlueTest Instruction Manual
bc01-an-047b
© Copyright CSR Ltd 2001
This material is subject to CSR’s non-disclosure agreement.
Page 8 of 56
BlueCore
TM
01
Title RXSTART1
Summary
Enables the receiver in continuous reception at a designated
frequency (LO Freq) with a choice of low or high side modulation
(hi-side) and with a designated attenuation setting (RX
Attenuation). Requires a second unit to be running TXSTART.
Routes final IF to TEST_A pin.
Test Arguments
LO Freq (Carrier Frequency MHz)= 2402 to 2480
hi-side (default = False) set 0 or 1
RX Attenuation = 0 to 15 (Default = 0)
Return Data None
Exit Click on Reset Chip.
RXSTART1 Example Display