User Manual
Table Of Contents
- Introduction
- Getting Started
- Simple Tests
- Quantitative Quantitative Tests
- Transmitter Only Transmitter Only
- Receiver Only
- Loopback Test Mode
- Configuration Commands
- Built-in-Self Test (BIST) Routines
- Miscellaneous Test Routines
- Persistent Store Keys
- Appendix 1 BIST Parameters
- Appendix 2 Known Software Issue(s) in BlueTest Version 1.4
- Appendix 3 Combining Tests Using a Second Unit
- Appendix 4 Configuration Commands Available During Tests
- Appendix 5 Bluetooth Packet Types
BlueTest Instruction Manual
bc01-an-047b
© Copyright CSR Ltd 2001
This material is subject to CSR’s non-disclosure agreement.
Page 30 of 56
BlueCore
TM
01
CFG TX TRIM Example Display
Title CFG TX TRIM
Summary
Sets the Active Member Address (am_addr) for the device
to be used in the header of all test transmissions to
am_addr. If the transmitter and receiver are used for the
same test, both devices will normally have to be set to the
same am
_addr.
Related Test Spec
Name
None
Test Arguments Trim (am_addr) = 0 to 7, Default = 7
Return Data None
Exit Click on Reset Chip.