User's Manual

Datalogic Scanning, Inc
959 Terry Street
Eugene, Oregon 97402
Page 19 10/23/2009
Revision X2
PSKEY_EDR_MODE_SWITCH_PIO 0x0052 uint16 none
This key will assert the PIO line specified, 0-15 if present, if the key is not present it will become a zero
length key with an attempt to read it failing, this will fail the psget method and disable use of this key. If
the pskey is defined but the value is 0xffff, out of bounds, then the key will not setup a pio line. The use of
this pskey is intended to be the mode select line for an EDR power amp, the assertion method will be in
PSKEY EDR_SWITCH_MODE,this will be either high to low or low to high.
If a pio line is required for tx enablement then you should use the PSKEY_TXRX_PIO_CONTROL
, pio
pin 1 which asserts when we are transmitting.
Key Name Key
Number
Type Default Setting
PSKEY_LC_ENABLE_WATCHDOG_FAULT 0x0053 bool FALSE
This is a debugging option; CSR internal use only.
Key Name Key
Number
Type Default Setting
PSKEY_LC_COMBO_DOT11_SIGNAL_BANDSCAN 0x0055 bool FALSE
This key controls BlueCore's co-existence signalling of AFH band scans using the co-existence signalling
PIOs. When this key is set, BlueCore to signal band scans as long receives.
PSKEY_LC_COMBO_DOT11_ABORT_BANDSCAN
controls whether BlueCore responds to abort
signals for band scans.
This key only applies to the Unity-3 wire co-existence scheme.
Key Name Key
Number
Type Default Setting
PSKEY_LC_COMBO_DOT11_ABORT_BANDSCAN 0x0056 bool FALSE
This key controls BlueCore's response to co-existence signalling during AFH band scans. When this key is
set, BlueCore will abort a band scan if the wifi device requests this during the time after BlueCore signals
its intention to receive but before the band scan starts. BlueCore will not abort a scan in progress after this.
This key has no effect if BlueCore has not been configured to signal band scans on the co-existence PIOs
by setting PSKEY_LC_COMBO_DOT11_SIGNAL_BANDSCAN
.
This key only applies to the Unity-3 wire co-existence scheme.
Key Name Key
Number
Type Default Setting
PSKEY_LC_PEER_POWER_INCR_PERIOD 0x0057 TIME 100000
The period, measured in microseconds, between attempts to increment the peer's transmit power.
Setting this to zero disables the periodic checks. This means the local device will not send messages
concerning power management or channel quality driven data rate to the remote device. This pskey is