User's Manual

Datalogic Scanning, Inc
959 Terry Street
Eugene, Oregon 97402
Page 121 10/23/2009
Revision X2
{ 80,
2 },
{ 100,
3 }
Table in the same form as PSKEY_TEMPERATURE_VS_DELTA_INTERNAL_PA used when transmitting
EDR packets.
Key Name Key Number Type Default Setting
PSKEY_MR_ANA_TX_MIXER_CONFIG 0x21e2 uint16 0x0005
This sets various values for configuring the transmit mixer on BC5 for medium rate (EDR) operation. This
PSKEY should only be changed on advice from CSR.
Key Name Key Number Type Default Setting
PSKEY_LO_LVL_TARGET 0x21e3 uint16 1569
Sets the desired amplitude for the (Bluetooth radio's) Local Oscillator.
(This is for CSR internal use only. If you don't know what it's for, don't play with it.)
Key Name Key
Number
Type Default Setting
PSKEY_DEEP_SLEEP_EXTERNAL_CLOCK_SOURCE 0x21e4 uint16 0
On devices where an external 32kHz sleep clock can be routed into one of several pins, this key controls
which pin is used.
Note that this only affects the clock source used for deep sleep timing, not the clock source to drive the FM
radio etc.
Valid values: 0 CLK32 (dedicated pin) 1 AIO0
It is ignored if PSKEY_DEEP_SLEEP_USE_EXTERNAL_CLOCK
is not set.
Key Name Key Number Type Default Setting
PSKEY_ANA_TX_MIXER_CONFIG 0x21e9 uint16 0x000b
This sets various values for configuring the transmit mixer on BC5 for basic rate operation. This PSKEY
should only be changed on advice from CSR.
Key Name Key Number Type Default Setting
PSKEY_PROG_PAGE_SIZE 0x21ea uint16 0
Flash page size over which extra wait states can be inserted.
This PSKEY should only be changed on advice from CSR.
Key Name Key Number Type Default Setting
PSKEY_PROG_ASYNC_EN 0x21eb uint16 0