Installation Instructions

Selecting the Interface Type
18 Gryphon™ I GBT4100
Interface Selection
Each reader model will support one of the following sets of host
interfaces:
General Purpose Models: RS-232, RS-232 OPOS, USB, Key-
board Wedge, Wand.
Retail Point of Sale Models : RS-232, RS-232 OPOS, USB, IBM
46XX.
Information and programming options for each interface type are
provided in this section.
Configuring the Interface
Scan the programming barcode which selects the appropriate in-
terface type matching the system the reader will be connected to.
If you need to customize additional settings and features associat-
ed with that interface, proceed to the corresponding chapter in
the Gryphon™ I PRG.
NOTE
Unlike some other programming features and options,
interface selections require that you scan only one pro-
gramming barcode label. DO NOT scan an ENTER/EXIT bar-
code prior to scanning an interface selection barcode.
Some interfaces require the scanner to start in the dis-
abled state when powered up. If additional scanner con-
figuration is desired while in this state, pull the trigger
and hold for 5 seconds. The scanner will change to a state
that allows programming with barcodes.
RS-232
RS-232 standard interface
Select RS232-STD
RS-232 Wincor-Nixdorf
Select RS232-WN