Installation Instructions

Linking the Reader to the Base Station
16 Gryphon™ I GBT4100
Linking the Reader to the Base Station
RF Devices
For RF devices, before configuring the interface it is necessary to
link the handheld with the base.
To link the handheld and the base, press the trigger to wake it and
place it on the base. If the reader was previously linked to another
base, you must first scan the Unlink action command before re-
linking to the new base.
System and Network Layout
Typical Setup with Cradle and Host
Figure 7. Reader Layout
Selecting the Interface Type
Upon completing the physical connection between the reader and
its host, proceed directly to
Interface Selection on page 18 for in-
formation and programming for the interface type the reader is
connected to (for example: RS-232, Keyboard Wedge, USB, etc.)
and scan the appropriate barcode to select your system’s correct
interface type.
Unlink