Certifications 2

8.2. Exposure controls
Safety signs
Precautionary measures to prevent exposure
Eye / face protection
Hand protection
Skin protection
Respiratory protection
Thermal hazards
Route of exposure: Saltwater sediments
Value: 552 mh/kg
Route of exposure: Freshwater sediments
Value: 552 mg/kg
Route of exposure: Saltwater
Value: 140,9 mg/l
Value: 140,9
Comments: Intermittent releases
Personal protection equipment should be chosen according to the CEN standards and
in discussion with the supplier of the personal protective equipment.
Wear approved safety goggles. (EN 166).
Use protective gloves made of: Butyl rubber. Neoprene. Nitrile. (EN 374)
Breakthrough time for nitrile rubber, neoprene and butyl rubber is approx. 3 hours.
The recommendation is a qualified estimate based on knowledge of the components.
Elastic gloves stretch when used as glove thickness and thus the breakthrough time
reduced.
The EN 374-3 standard test is performed at 23°C, but the practical temperature of the
glove is approx. 35°C.
The breakthrough time of the different glove guides, is therefor reduced by a factor 3.
No special precautions.
In case of inadequate ventilation or risk of inhalation of vapours, use suitable
respiratory equipment with combination filter (type A2/P2).
See section 5.
Technical measures to pre-
vent exposure
Suitable eye protection
Skin- / hand protection, long
term contact
Hand protection, comments
Additional skin protection
measures
Respiratory protection nec-
essary at
Thermal hazards
Label remover spray - Version 4 Page 6 of 13
This document is created with Eco Publisher (EcoOnline) Revision date 08.05.2018