User Manual

Parts Included:
1. 45-0021-WH Recessed Low Voltage Cable Plate
with Recessed Power
2. Recessed Low Voltage Cable Plate with Recessed
Locking Inlet
3. 6 Ft. 14/2 with Ground Extension Cord
Use the Recessed Low Voltage Cable Plate with Recessed
Locking Inlet to install power and low voltage cables behind your
flat panel TV, amplifier or other audio and video devices to your
equipment room or at the location of your head end equipment.
IMPORTANT INSTRUCTIONS:
 Use the local electrical code approved installation when
installing this product.
 The electrical parts in this kit are designed to be used
only as a kit and none of these electrical parts are
designed to be used individually.
 This product is not designed to be part of your home or a
commercial building’s electrical wiring system.
 This installation is only energized (electrically active)
when the supplied 6 ft. cord is plugged into the recessed
locking inlet located on the recessed low voltage cable
plate and the locking end of the 6 ft. cord is plugged into
either your surge protector or wall receptacle.
 If you are not familiar with home wiring systems, please
call a qualified electrician to install this product.
Installation Instructions for New Construction:
Simply use a new nail on box and follow all other instructions
described in the retrofit portion of the instruction sheet.
Installation Instructions for Retrofit Only:
1. Select the location of your flat panel TV mounting
bracket. Now select the location for both the 45-0021-
WH Recessed Low Voltage Cable Plate with Recessed
Power and the Recessed Low Voltage Cable Plate with
Recessed Locking Inlet.
2. Both the Recessed Low Voltage Cable Plate with
Recessed Power and the Recessed Low Voltage Cable
Plate with Recessed Locking Inlet are designed to be
mounted between two studs (see Figure 1). Using the
template supplied (see back of instruction sheet), trace
the openings needed for both recessed cable plates.
Using a drywall knife cut a hole in the drywall the size of
the template.
3. Remember that the Pro-Power kit is not part of your
home’s electrical wiring system. Before installing the
single gang retrofit workboxes (see Figure 2), pull a
piece of 12/2 or 14/2 with ground UL approved building
wire from one opening to the other opening to connect
the recessed cable plate with recessed power to the
recessed cable plate with recessed locking inlet. Make
sure the piece of wire is long enough to allow for easy
installation of the receptacles. Insert a single gang
retrofit workbox (see Figure 2). Securely fasten the
workbox to the wall.
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.datacommelectronics.com
Instruction / Installation Sheet
DataComm Electronics 45-0022-WH Recessed Pro-Power Kit with Locking Inlet
Figure 3 Figure 4
Figure 1 – Front View
Figure 2 – Back View
3/22/10 Rev. 8