Specifications

Operations Manual, Redundant System Controllers 209351 REV B 37
3.3.5 Options Menu
This section describes the features available on the Options menu of the controller. The
operation parameters can be accessed from the VFD menu. From the main menu
screen, select “Options”. See Figure 3-9. The following option selections are available.
3.3.5.1 Backup
Allows the user the ability to store all settings to nonvolatile memory.
3.3.5.2 Restore
Restore previously saved settings.
User – Previously saved settings from using the “Backup” selection
Factory Default – Original settings as shipped from the factory
3.3.5.3 Lamp Test
Tests all front panel LEDs. The LEDs remain on until the “Enter” key is pressed.
3.3.5.4 Password
Allows the user to set a password that prohibits others from changing settings on the
controller.
Set - Enables password protection
Clear– Disables password protection
Change – Allows the user to set a numeric password between 1 and 255. Use
the Arrow keys to set the numeric password. The Up Arrow (▲) and Down
Arrow (▼) keys change the numeric password by factors of 10. The Left Arrow
(◄) and Right Arrow (►) keys change the password in increments of 1.
Figure 3-9: Options Parameters Menu
2.Com Setup1.Sys Info 3.Operation 4.Flt. Setup 5.Options
Main Menu
6.Calibr
1.Backup 2.Restore 3.Lamp Test 4.Password 5.Reset 6.More
1.User 2.Factory
1.Set 2.Clear 3.Change
0..255
4.Flt. Tolerance1.Sys ID 2.LCD Light 3.SSPA
4.Units
1.None 2.1 Fault 2.2 Faults
1.Low
2.Medium 3.High
3.Mute2.Attenuation
1.Sys. Type 2.Sw. Mute
1.SSPA Info
ON / OFF0 ... 20 dB
1.dBm 2.Watts
See Figure
5.More
1.None 2.RM SSPA 3.CO SSPA 4.vBUC
3.Atten Offset
1.SwMute Off 2.Internal On 3.External On 4.All On
1.Unit 1 2.Unit 2 3.Unit 3
3-5