Specifications

Operations Manual, Redundant System Controllers 209351 REV B 33
3.3.2 Serial Communication Parameters
This section describes the serial communication parameters that can be selected for the
controller. Press the Main Menu key; select 2.ComSetup and press the Enter key.
See Figure 3-6. Changes in Serial Communication settings from the front panel are ef-
fective immediately. Changes to these parameters from the serial interface
require that the controller be reset in order to take effect. The controller can be reset ei-
ther by cycling power to the unit or by selecting the reset option on the front panel menu
(see Section 3.3.5.5).
3.3.2.1 Protocol
This menu selection allows the user ability to select between the following protocols:
Normal - Selects only the Paradise Datacom protocol
Terminal - Selects only the terminal protocol. See Appendix A for more info.
3.3.2.2 Baud Rate
Selects the desired Baud Rate to use for serial communication. Valid options are: 2400,
4800, 9600, 19200 and 38400.
Figure 3-6: Serial Communication Parameters Menu
2.Com Setup
3.Sys Addr
1.2400
1.RS232
3.Subnet
1.Community Get
1.Sys Info
2.Baud Rate
2.Terminal
1-255
2.LocalIP
3.Operation
4.Interface
2.4800
2.RS485
4.Gateway
2.Community Set
4.Flt. Setup
5.IP Setup
3.9600
3.IPNet
5.LocalPort
4.Web Password
5.Options
4.19200
4.SNMP
6.More
1.Protocol
1.Normal
5.38400
1.IPInfo
Main Menu
6.Calibr
To IP Info Page
3.Lock IP