Specifications

Operations Manual, Redundant System Controllers 209351 REV B 31
3.3.1.7 SSPA Subsystem Information - Pages 1-5
Page 1 (RCP firmware version 3.10 or better) pertains to conditions and settings
common to all SSPAs in a subsystem.
Page 2 (RCP firmware version 3.60 or better) pertains to individual SSPA output power
levels.
Page 3 (RCP firmware version 3.10 or better) pertains to each individual SSPA unit’s
core temperature and ambient temperature.
Page 4 (RCP firmware version 3.60 or better) pertains to individual SSPA unit’s DC
current consumption.
Page 5 (RCP firmware version 3.30 or better) pertains to additional subsystem
settings.
See Section 4.6 for a thorough description of this series of menus.
3.3.1.8 IP Info - Page 1
This page is available through the ComSetup menu, and shows settings related to the IP
interface. See Figure 3-5.
IP Address: IP address of the RCP . Consult your network administrator to set
this address according to your LAN configuration.
MAC: Medium Access Control address of the RCP Ethernet controller. This
address is factory preset.
Subnet: IP subnet mask of the RCP. Consult your network administrator to set
this address.
IPPort: IP port value for the RCP. This address is valid only when IPNet
protocol is selected. The port value should not be selected outside the existing
services range to avoid access conflict on the M&C PC end.
3.3.1.9 IP Info - Page 2
This page shows RCP settings related to the IP interface.
Gateway: IP Gateway address. This address is used only if access to the RCP is
provided from an outside LAN. If no such access is required, the address must be
set to 0.0.0.0
LockIP: This address is used to increase the security measure for the IPNet
protocol. The RCP will answer a request which comes only from a specified IP
address. Set this address value to 0.0.0.0 or 255.255.255.255 to disable this
feature.