Specifications

Operations Manual, Redundant System Controllers 209351 REV B 121
If the Amplifier Local Port is changed the RCP unit must be reset. The Gateway
Address and Subnet Mask are standard settings for TCPI/IP communications. If either
of these settings is changed the RCP unit must be reset for the new settings to take
effect. The IP Lock Address is used for security. If it is set to something besides 0.0.0.0
or 255.255.255.255 it will only answer the address it is set to. For example, if the IP
Lock Address is 192.168.0.50 then a request from 192.168.0.100 will not be accepted.
The IP Lock Address may be changed without resetting the RCP unit.
The third screen displays the Conditions of the units connected to the controller, as
shown in Figure C-4. The system forward power, reflected power, power supply volt-
ages and LNA/LNB currents and temperatures are all monitored. In addition, the cali-
bration points of each LNA/LNB are displayed.
The fourth screen is the “Settings” screen, shown in Figure C-5. It shows the user all
available settings on the RCP unit. All user-adjustable settings may be modified to suit
the specific needs of the customer. However, it should be noted that the RCP units are
pre-configured for the customer at the factory. If modification of any settings is neces-
sary please refer to the Table 7-6.
Figure C-4: Conditions Window
Figure C-5: Settings Window