Specifications

Operations Manual, Redundant System Controllers 209351 REV B 119
C.1 Adding a New RCP Unit to the Universal M&C
To add a new unit, choose "Action->Add Unit" from the Main Menu. Then choose
"RCP2 Redundancy Controller". When a unit type is chosen a "New RCP2" dialog win-
dow will appear for the particular unit you are adding, as shown in Figure C-1.
To add a RCP unit to the M&C Utility, fill in the appropriate boxes in the "New RCP2"
dialog. A Unit ID is not required although it is recommended. If a Unit ID isn't entered
the Unit ID will be assigned by the M&C. Select the system configuration
(One_to_Two, One_to_One, Phase_Combined, or Dual_One_to_One).
To add a unit connected to a serial port you must supply a Port and a Baud Rate.
To add a unit connected via UDP (TCP/IP) you must supply either a Hostname or an
IP Address
Specify the Unit's Unique Address in the RCP2 Address box. If you don't know the
address of the unit you may search for it. Be aware that this search feature is only
useful when you have only one unit connected to your PC at a time.
Figure C-1: New RCP2 Dialog Window
Appendix C: RCP Control
with Paradise Datacom Universal M&C